Document Type : ORIGINAL RESEARCH ARTICLE

Authors

1 Department of Watershed Management, Faculty of Natural Resources and Environment, University of Birjand, Birjand, Iran

2 Department of Water Engineering, Faculty of Civil Engineering, University of Tabriz, Tabriz, Iran

Abstract

Hydrologic modeling of semi-arid watersheds is imperative for the development of appropriate water and soil conservation plans. In the current study, the efficiency of Kinematic Runoff and Erosion model-version 2 (K2) model was used to evaluate water discharge and sediment load simulation of Bar watershed, located in the north-eastern part of Iran. The K2 model relies on the kinematic wave approach to route surface flow. The drainage network and planes are discretized to represent the watershed. In order to evaluate the model, 3 and 2 reported rainfall incidents in various dates were selected for K2 calibration and validation, respectively. The multiplier approach was employed for model calibration. The results of sensitivity investigation revealed that the soil parameters Ks-CH, n and G had the highest impact on flow discharge. Through the calibration process, the Nash-Sutcliff Efficiency and the coefficient of determination as fitting metrics for water discharge simulation (based on event #2, dated 16 March 1992) were estimated to be 0.78 and 0.88, respectively. According to the aggregated measure, the highest K2 efficiency was obtained during the calibration process based on event #2. Other storm events were resulted in a good simulation, as well. During the validation process, K2 simulation (based on event #4, dated 07 March 1991) led to the Nash-Sutcliffe Efficiency and R2 of 0.77 and 0.71, respectively. The K2 calibration for sediment load simulation was performed through the alterations of the Pave and Rainsplash parameters. The bias percentages between simulated and observed total sediment loads based on events #2 and #4 were 5% and 16%, respectively. Conclusively, the K2 model showed an acceptable robustness in the hydrological simulation of Bar watershed as a representative semi-arid watershed in northeast of Iran.

Graphical Abstract

Kinematic runoff and erosion model efficiency assessment for hydrological simulation of semi-arid watersheds

Highlights

  •  Proper efficiency and acceptable robustness of the KINEROS2 (K2) for hydrological simulation of semi-arid watersheds, in which there is a lack of precipitation data with densely spatial distribution
  • Significant impact of soil properties on hydrological simulation, explored through a multiplier-based calibration and sensitivity analysis
  • High capability of the runoff-based optimized K2 for sediment load simulation of semi-arid watersheds

Keywords

Main Subjects

Letters to Editor

GJESM Journal welcomes letters to the editor for the post-publication discussions and corrections which allows debate post publication on its site, through the Letters to Editor. Letters pertaining to manuscript published in GJESM should be sent to the editorial office of GJESM within three months of either online publication or before printed publication, except for critiques of original research. Following points are to be considering before sending the letters (comments) to the editor.

[1] Letters that include statements of statistics, facts, research, or theories should include appropriate references, although more than three are discouraged.
[2] Letters that are personal attacks on an author rather than thoughtful criticism of the author’s ideas will not be considered for publication.
[3] Letters can be no more than 300 words in length.
[4] Letter writers should include a statement at the beginning of the letter stating that it is being submitted either for publication or not.
[5] Anonymous letters will not be considered.
[6] Letter writers must include their city and state of residence or work.
[7] Letters will be edited for clarity and length.

CAPTCHA Image